RED DSMC2 V-Lock I/O module
The RED DSMC2 V-Lock I/O module offers a variety of input/output connections as well as a standard V-Lock mount that can accommodate RED BRICK batteries to power your DSMC2 system. Constructed from strong, lightweight magnesium, this extension mounts directly to the rear of your BRAIN RED camera body (Weapon 6K, Scarlet-W, Raven) and offers the following connections:
- DC Power input (DC IN)
- HDMI 1.2 output (Type A socket)
- 3G-SDI output (HD-SDI, 75 Ω BNC)
- CTRL & SYNC ports (2x 00B LEMO 4-Pin, Timecode and Genlock support)
- AUX Power output (P-Tap 2-Pin female)
- USB Power output (Type A, 5 V at 1.5 A for powering HDMI transmitters or small mobile devices)
- Stereo Headphone output (3.5 mm jack)
- Stereo Analog input (3.5 mm jack)
The DSMC2 V-Lock I/O module also features a switch that enables the camera to switch on and off automatically when powered via the DC IN connector.
A solution for situations requiring mobility.
NOTE: The DSMC2 Top Handle is not compatible with this module when a battery is attached.
Videos
| DIMENSIONS | Height: 4.57 in. (116.0 mm) |
| Width: 4.94 in. (125.5 mm) | |
| Depth: 2.25 in. (57.2 mm) (connected to BRAIN) | |
| WEIGHT | 1.0 lb (454 g) |
| MATERIAL | Magnesium |
| BRAIN MOUNTING | 4x M4 captive mounting screws |
| BRAIN CONNECTIONS | Power delivery via Rear pogo connector (13-Pin) |
| Communication via Rear I/O connector (4×40 Pin) | |
| CONNECTORS | DC IN (6-Pin 1B LEMO socket) |
| 3G-SDI output (75 Ω BNC), 60 Hz max frame rate | |
| HDMI 1.2 output (Type A socket), 60 Hz max frame rate | |
| SYNC (Genlock IN / Timecode IN / Sync IN) (4-Pin 00B LEMO socket) | |
| CTRL (Tally OUT / RS-232 Rx and Tx) (4-Pin 00B LEMO socket) | |
| USB Power output (Type A socket), 1.5A | |
| P-Tap Aux Power output (2-Pin), 3.0A | |
| Stereo Analog Microphone input (3.5mm jack) | |
| Stereo Headphone output (3.5mm jack) | |
| AUTO BOOT ON POWER | 2-position slider switch |
| BATTERY COMPATIBILITY | RED BRICK |
| AUDIO | 24-bit, 48 KHz, uncompressed, unbalanced mic level |
| OPERATING TEMPERATURE | 0°C to 40°C (32°F to 104°F) |
| STORAGE TEMPERATURE | -20°C to 50°C (-4°F to 122°F) |
| OPERATING HUMIDITY | 0% to 85%, non-condensing |
| STORAGE HUMIDITY | 0% to 85%, non-condensing |
| FIRMWARE REQUIREMENT | Compatible with all DSMC2 firmware v6.2.17 or later. |